ref: efd1615c5741a6898853fefc24b1cbcb734e5477
dir: /os/boot/pc/ether2000.c/
#include "u.h"
#include "lib.h"
#include "mem.h"
#include "dat.h"
#include "fns.h"
#include "io.h"
#include "etherif.h"
#include "ether8390.h"
/*
* Driver written for the 'Notebook Computer Ethernet LAN Adapter',
* a plug-in to the bus-slot on the rear of the Gateway NOMAD 425DXL
* laptop. The manual says NE2000 compatible.
* The interface appears to be pretty well described in the National
* Semiconductor Local Area Network Databook (1992) as one of the
* AT evaluation cards.
*
* The NE2000 is really just a DP8390[12] plus a data port
* and a reset port.
*/
enum {
Data = 0x10, /* offset from I/O base of data port */
Reset = 0x1F, /* offset from I/O base of reset port */
};
int
ne2000reset(Ether* ether)
{
ushort buf[16];
ulong port;
Dp8390 *ctlr;
int i;
uchar ea[Eaddrlen];
/*
* Set up the software configuration.
* Use defaults for port, irq, mem and size
* if not specified.
*/
if(ether->port == 0)
ether->port = 0x300;
if(ether->irq == 0)
ether->irq = 2;
if(ether->mem == 0)
ether->mem = 0x4000;
if(ether->size == 0)
ether->size = 16*1024;
port = ether->port;
ether->ctlr = malloc(sizeof(Dp8390));
ctlr = ether->ctlr;
ctlr->width = 2;
ctlr->ram = 0;
ctlr->port = port;
ctlr->data = port+Data;
ctlr->tstart = HOWMANY(ether->mem, Dp8390BufSz);
ctlr->pstart = ctlr->tstart + HOWMANY(sizeof(Etherpkt), Dp8390BufSz);
ctlr->pstop = ctlr->tstart + HOWMANY(ether->size, Dp8390BufSz);
ctlr->dummyrr = 1;
for(i = 0; i < ether->nopt; i++){
if(strcmp(ether->opt[i], "nodummyrr"))
continue;
ctlr->dummyrr = 0;
break;
}
/*
* Reset the board. This is done by doing a read
* followed by a write to the Reset address.
*/
buf[0] = inb(port+Reset);
delay(2);
outb(port+Reset, buf[0]);
delay(2);
/*
* Init the (possible) chip, then use the (possible)
* chip to read the (possible) PROM for ethernet address
* and a marker byte.
* Could just look at the DP8390 command register after
* initialisation has been tried, but that wouldn't be
* enough, there are other ethernet boards which could
* match.
*/
dp8390reset(ether);
memset(buf, 0, sizeof(buf));
dp8390read(ctlr, buf, 0, sizeof(buf));
if((buf[0x0E] & 0xFF) != 0x57 || (buf[0x0F] & 0xFF) != 0x57){
free(ether->ctlr);
return -1;
}
/*
* Stupid machine. Shorts were asked for,
* shorts were delivered, although the PROM is a byte array.
* Set the ethernet address.
*/
memset(ea, 0, Eaddrlen);
if(memcmp(ea, ether->ea, Eaddrlen) == 0){
for(i = 0; i < sizeof(ether->ea); i++)
ether->ea[i] = buf[i];
}
dp8390setea(ether);
return 0;
}