ref: 9eaba52cafcac7c2f3bfc72d7be1f15893196be1
dir: /DoConfig/fltk/zlib/uncompr.c/
/* uncompr.c -- decompress a memory buffer
* Copyright (C) 1995-2003, 2010 Jean-loup Gailly.
* For conditions of distribution and use, see copyright notice in zlib.h
*/
/* @(#) $Id$ */
#define ZLIB_INTERNAL
#include "zlib.h"
/* ===========================================================================
Decompresses the source buffer into the destination buffer. sourceLen is
the byte length of the source buffer. Upon entry, destLen is the total
size of the destination buffer, which must be large enough to hold the
entire uncompressed data. (The size of the uncompressed data must have
been saved previously by the compressor and transmitted to the decompressor
by some mechanism outside the scope of this compression library.)
Upon exit, destLen is the actual size of the compressed buffer.
uncompress returns Z_OK if success, Z_MEM_ERROR if there was not
enough memory, Z_BUF_ERROR if there was not enough room in the output
buffer, or Z_DATA_ERROR if the input data was corrupted.
*/
int ZEXPORT uncompress (dest, destLen, source, sourceLen)
Bytef *dest;
uLongf *destLen;
const Bytef *source;
uLong sourceLen;
{
z_stream stream;
int err;
stream.next_in = (z_const Bytef *)source;
stream.avail_in = (uInt)sourceLen;
/* Check for source > 64K on 16-bit machine: */
if ((uLong)stream.avail_in != sourceLen) return Z_BUF_ERROR;
stream.next_out = dest;
stream.avail_out = (uInt)*destLen;
if ((uLong)stream.avail_out != *destLen) return Z_BUF_ERROR;
stream.zalloc = (alloc_func)0;
stream.zfree = (free_func)0;
err = inflateInit(&stream);
if (err != Z_OK) return err;
err = inflate(&stream, Z_FINISH);
if (err != Z_STREAM_END) {
inflateEnd(&stream);
if (err == Z_NEED_DICT || (err == Z_BUF_ERROR && stream.avail_in == 0))
return Z_DATA_ERROR;
return err;
}
*destLen = stream.total_out;
err = inflateEnd(&stream);
return err;
}